Maintenance
keying dowel axial set screw
clamping washer
slot
(Defect ball until this area is flush
with the clamping washer before
tightening the dowel set screws)
preload set screw
keying dowel
(chamfer pointed out)
keying dowel radial set scres
rear housing
(shown transparent
Rear Housing
Assembly
Replacement
1. Remove the brass plug or hex socket screw from the center of
the deburring unit's rear housing.
2. Remove the socket head screws securing the rear housing to
the deburring tool's front housing.
3. Remove the rear cover complete with the pivot bearing. Retain
the small o-ring and dowel pin between the cover and housing
for reuse if desired.
4. The new rear housing assembly will be provided with new
fasteners and a new o-ring. Reassembly is the reversal of the
previous steps with the following points:
✓
Insure the dowel pin and small o-ring that go between the
housing and the rear cover are in place before refitting the
rear cover.
✓
Use liquid thread locker on all the socket head screws, but
NOT on the brass pivot post plug (where applicable).
✓
Insure that the spindle air supply fitting is centered in the
housing (side boot) opening prior to tightening the fastener
in the pivot bearing post.
Pivot Bearing &
Keying Dowel
Replacement
NOTE
Always replace the pivot bearing keying dowel when the bearing
is replaced
1. Remove the rear housing assembly as described above.
2. Remove the three socket head screws securing the pivot
bearing in the center of the rear housing.
3. Remove the large clamping washer which rests on top of the
pivot bearing.
4. Locate and loosen the radially tapped bearing preload set
screw in the rear housing.
47
04.00 | FDB | Assembly and Operating Manual | en | 389072
