•
9
•
When the product is inflated to the desired level, push the Compressor/Inflator switch
6.
to the OFF position and remove the adapter.
Estimated Time for Inflating
24” Beach Ball
1 to 3 minutes
Pool Raft
4 to 6 minutes
Queen-Size Air Mattress
4 to 8 minutes
2 Person Boat
8 to 10 minutes
Times are estimates and will vary depending on size and product features.
Using the Deflator
11.8
Ensure the battery clips are securely on the storage holders.
1.
Attach the corrugated hose with the end adapter to the high-flow deflator outlet which
2.
is located on the side of the Instant Power™.
The main accessory adapter attached to the corrugated hose accommodates up to 4
3.
sizes. If another size is needed, an additional adapter can be attached to the end of
the main accessory adapter.
Insert the adapter into the item to be deflated.
4.
Push the Compressor/Inflator switch to the INFLATOR position and deflate the item.
5.
When the product is deflated to the desired level, push the Compressor/Inflator
6.
switch to the OFF position and remove the adapter.
Before Using the Inverter
11.9
Important Safety Instructions:
Keep the Instant Power™ well ventilated in order to properly disperse heat generated
1.
while it is in use. Make sure there are several inches of clearance around the top and
sides, and do not block the vents on the back of the Instant Power™.
Make sure the Instant Power™ is not close to any potential source of flammable
2.
fumes, gases or clothing.
Keep the Instant Power™ dry.
3.
DO NOT allow the Instant Power™ to come into contact with rain or moisture.
4.
DO NOT operate the Instant Power™ if you, the Instant Power™, the device being
5.
operated or any other surfaces that may come in contact with any power source are
wet. water and many other liquids can conduct electricity, which may lead to serious
injury or death.
Do not place the Instant Power™ on or near heating vents, radiators or other
6.
sources of heat.
Do not place the Instant Power™ in direct sunlight. The ideal air temperature for
7.
operation is between 50° and 80°F.
Do not use the inverter near an open engine compartment where fumes or gases
8.
may accumulate.
Do not modify the AC receptacles in any way.
9.
Using the Inverter
11.10
It is important to know the continuous wattage of the device you plan to use with the
inverter. The Instant Power™ must be used with devices drawing 400 watts or less. If
the wattage is not marked on the device, use only devices that draw less than 3.4 Amps
of AC current.
Devices like TVs, fans or electric motors require additional power to start (commonly
known as the “starting or peak power”). The Instant Power™ can supply a momentary
surge in wattage; however even devices rated less than the maximum 400 watts can
exceed the inverters surge capability and cause an automatic overload shutdown.
Do not use the inverter with a product that draws a higher wattage than the inverter can
provide, as this may cause damage to the inverter and the product.
