•
6
•
CHARGE RATE
The charger will automatically adjust the
charging current, based on battery size,
in order to charge the battery completely,
efficiently and safely.
BATTERY CHARGING TIMES
Times are based on a 50% discharged
battery and may change, depending on age
and condition of battery.
AUTOMATIC CHARGING MODE
When the Automatic Charge is performed,
the charger switches to the maintain
mode automatically after the battery is
charged.
ABORTED CHARGE
If charging cannot be completed normally,
charging will abort. When charging aborts,
the charger’s output is shut off and the
CHARGING
(yellow/orange) LED will
flash. To reset after an aborted charge,
unplug the charger from the AC outlet,
wait a few moments and plug it back in.
DESULFATION MODE
Desulfation could take 8 to 10 hours.
If desulfation fails, charging will abort and
the
CHARGING
(yellow/orange) LED
will flash.
COMPLETION OF CHARGE
Charge completion is indicated by the
CHARGED
(green) LED. When
pulsing, the charger has switched to the
maintain mode of operation.
MAINTAIN MODE
(FLOAT-MODE MONITORING)
When the CHARGED
(green) LED is
pulsing, the charger has started maintain
mode. In this mode, the charger keeps the
battery fully charged by delivering a small
current when necessary. If the charger
has to provide its maximum maintain
current for a continuous 12 hour period,
it will go into abort mode (see Aborted
Charge section). This is usually caused by
a drain on the battery or the battery could
be bad. Make sure there are no loads on
the battery. If there are, remove them. If
there are none, have the battery checked
or replaced.
MAINTAINING A BATTERY
The SC-1200A-CA and SSC-1500A-CA
maintain both 6 and 12 volt batteries,
keeping them at full charge.
NOTE:
The maintain mode technology
allows you to safely charge and maintain
a healthy battery for extended periods
of time. However, problems with the
battery, electrical problems in the
vehicle, improper connections or other
unanticipated conditions could cause
excessive current draws. As such,
occasionally monitoring your battery and
the charging process is required.
USING THE BATTERY VOLTAGE
TESTER
1.
With the charger unplugged from the
AC outlet, connect the charger to the
battery following the instructions given
in previous sections.
2.
Plug the charger AC power cord into
the AC outlet.
3.
If necessary, press the BATTERY
TYPE button until the correct type is
indicated.
4.
Read the voltage on the digital display.
Keep in mind that this reading is only a
battery voltage reading; a false surface
charge may mislead you. Compare the
reading to the chart below.
6 V Battery
Voltage
Reading
12 V Battery
Voltage
Reading
Battery
Condition
6.4 or more
12.8 or more
Charged
6.1 to 6.3
12.2 to 12.7
Needs
charging
Less than 6.1 Less than 12.2
Discharged
POWER-UP IDLE TIME LIMIT
If no button is pressed within 10 minutes
after the battery charger is first powered
up, the charger will automatically switch
from tester to charger if a battery is
connected. In that case, the charger will
be set to charge at the 3A rate and AGM
battery type (SC-1200A-CA) or gel cell
battery type (SSC-1500-CA).
TESTING AFTER CHARGING
After the unit has been changed from
tester to charger (by selecting a charge
rate), it remains a charger. To change the
battery charger back to a tester, press the
CHARGING RATE button until all charge
rate LEDs are off.
