• 4 •
3. OPERATING INSTRUCTIONS
3.1 To insert batteries (3 AAA, not included), remove the three screws on the back and
open the case. When finished, close the case, replace and tighten the screws.
3.2 Use the magnet on the back, to attach to any magnetic metal surface.
3.3 The LED Road Flare is waterproof. It may be safely used for marine applications and
in wet environments, and submerged to a depth of 33 feet. It will float unless secured.
3.4 Press the light mode selector to rotate through the following 9 light patterns:
1. Rotate
2. Quad flash
3. Single blink
4. Alternating blinks
5. SOS rescue (Morse code)
6. Steady on: high
7. Steady on: low
8. 2 LED Flashlight
9. 4 LED Flashlight
10. OFF
3.5 Alternate operation: To turn off the flare without cycling through the 9 light patterns,
press and hold the light mode selector for 2 seconds. Two LEDs will flash five times
and then turn off. When ready to operate again, press th light mode selector and it
will return to the last flash pattern that was selected before turning off.
3.6 Press the ON/OFF power button to turn the center warning lights on and off.
4. MAINTENANCE AND STORAGE INSTRUCTIONS
4.1 Store inside, in a cool, dry place.
4.2 Do not use alcohol, flammable solutions, or other solvents on or near this unit.
Clean only with warm water and a soft cloth.
4.3 Any servicing should be performed by qualified service personnel.
5. TROUBLESHOOTING
PROBLEM
SOLUTION
The flare does not operate.
Make sure the batteries are inserted correctly.
Replace the batteries, if necessary.
