Schulze BLUEpress, Instruction Manual

Page: 16 / 27

4.5 Replacing the electronic devices
Inside the upper part of the press there are electronic devices, which control the temperature and time of the press.
To exchange the electronic devices,
turn off the press and pull the plug . Loosen the srews in the upper part of the press (photo 1)
and remove the cover (photo 2) . Loosen the stopper of the electronic devices (photo 3) . pull out the green plug and remove the electonic
divices (photo 4).
Connect the new electronic devices and fix them into the press . Then reassemble the press again.
4.6 Replacing the silicon mat
To exchange the silicon mat the press must be disconnected from the electricity and cold. For the exchange you need a new silicon mat,
silicon glue, acetone and a notched trowel.
1. Remove the silicon mat with a knife restless.
2. Put an equal film of silicon glue on the plate using the notched trowel.
3. Put on the new silicon mat.
4. Close the pressure lever to press the silicon mat and the plate together.
5. Open the pressure lever and make sure that the plate and the mat lays exactly over each other.
6. Let the glue dry for 24hours.
7. Take of the heating plate and cut off the overlaying edge of the silicon mat.
Version 11.01 16