Schulze BLUEpress, Instruction Manual

Page: 11 / 27

3.4 Application range and sample adjustments of the press
This press is used to put transfers and transfer films on textiles. To get good achievements, get in contact with the producer of the textiles.
Here are some settings:
Film Flex 150°C – 160°C Time 15 Seconds
Film Flex S 155°C – 160°C Time 15 Seconds
Film A-Flex 155°C – 160°C Time 15 Seconds
Film Flock 160°C – 180°C Time 15 Seconds
Sublimation Film 190°C – 205°C Time 50 Seconds
All information is supplied without liability, please run your own testing before production.
3.5 Pressure settings
Wit this press you can change the pressure setting .
After every change of the pressure settings, close the heat press to check the new settings.
Damages, which arise from to much pressure, are excluded from the guarantee.
To adjust the pressure do the following:
1.
Take the pressure reading.
2. To alter the pressure pull the knop to you. (photo 1)
◦
Rotating the konp to the rigth will increase the pressure (photo 2)
◦ Rotating the konp to the left will decrease the pressure (photo 2)
3. To retain the setting push the knop to the press again.
The pressure reading you may take at the top on the right.
1,0 bar - ca. 415 kg
2,0 bar - ca. 830 kg
3.0 bar - ca. 1245 kg
4.0 bar - ca. 1660 kg
5,0 bar - ca. 2075 kg
6.0 bar - ca. 2490 kg
It is recommended to keep the pressure accordingly
Plate 20 x 20 cm ~ 0,3 bar (max. 0,6 bar)
Plate 38 x 45 cm ~ 2 bar (max. 4,0 bar)
Plate 40 x 50 cm ~ 2,5 bar (max. 4,5 bar)
If you alter the pressure to a setting higher than 6 bar, a safety valve will be activated. In this case you have to reduce the pressure.
Version 11.01 11