38
To assemble and use the detergent container, do the following:
1.
Make sure the gun’s trigger is in OFF position and that the pressure washer is off.
2.
Fill the container with adequate biodegradable detergent (Chapter “Safety instructions”).
3.
Connect and fix the container to on the spray nozzle (only for 1350W, 1400W and 1450W).
4.
Connect the container nozzle to the trigger gun + extension wand (Figure 8.11 and 8.12).
5.
Pull the nozzle forward to spray detergent (1700W, 2000W and 2600W Figures 8.13, 8.14 and 8.15).
6.
Release the lock on the gun trigger, turn on the pressure washer and direct the nozzle to the area to be sprayed.
7.
Pull the trigger and spray the desired area with detergent/foam.
Before using the detergent container nozzle, mare sure people and animals are out of
the spray range.
This equipment was designed to be used exclusively with cleaning products recommended by the manufactu-
rer - Chapter “Safety instructions”. The use of other chemicals might affect the equipment safety adversely.
ATTENTION
FIGURE 8.11
FIGURE 8.12
COVER
ADJUSTABLE NOZZLE CLEANING
FIGURE 8.13
FIGURE 8.14
FIGURE 8.15
COVER
ADJUSTING THE SPRAY
The spray nozzle is adjustable to allow you to adjust the water spray accor-
ding to your needs and the work to be performed (wide jet with less pressure
or intense jet).
Adjust the nozzle as follows:
1.
Hold the trigger gun with one hand.
2.
Twist the nozzle with the other hand.
3.
The intense jet must be used to clean small areas where more pressure
and cleaning force are required.
4.
The wide jet must be used for large cleaning areas that don’t require so
much pressure to remove the dirt.
DETERGENT FOAM SPRAY
FIGURE 8.10
FAN
PRESSURE
STREAM
SPRAY DETERGENT
NORMAL OPERATION