36
To avoid potential damages to your equipment you need to connect the inlet hose, let water flow
and pull the gun trigger to remove all the air from the system until only water comes out, before
turning the pressure washer on.
Check also the water inlet filter periodically and perform cleaning, if necessary. (Figure 8.8)
Before using the pressure washer, make sure there aren’t people or pets in the workplace.
Always when using an electrical product, certain basic safety precautions must be followed in order to reduce risks of fire,
electric shock and injury.
Make sure the pressure washer is off and unplugged from the power outlet before starting the following procedures of
preparation for use.
To ensure quality service, using the retractable reel with hole Hidrolav.
ATTENTION
ASSEMBLY AND REPAIRS
To prepare the pressure washer for use, follow the following instructions:
1.
Fix the fitting at the end of the hose to the trigger gun firmly (Figure 8.1).
2.
Fix the fitting of the hose to the outlet fitting of the pressure washer (Figures 8.2 and 8.3); Hand tighten the
fitting, do not use a wrench to avoid damaging the fitting.
3.
Press the lock-on button of the trigger gun to lock the trigger in the OFF position (Figures 8.4, 8.5 e 8.6).
4.
Connect the water inlet hose to the pressure washer (Figure 8.8)
Note: the inlet hose is not supplied with the product.
5.
Only in the 1350W and 1400W model, connect the extension wand to the trigger gun.
6.
Connect the spray nozzle to the prior set (Figure 8.7)
7.
Let water flow, make sure the flow regulator valve is fully open and there is no air in the system.
8.
Connect the plug to the power outlet.
9.
Release the lock-on button. “ON” unlocked, “OFF” locked (Figure 8.4, 8.5 e 8.6)
10.
Press the On/Off button to turn it on.
11.
Only in 2000W and 2600W models, pull the trigger gun and unreel the hose to desired length.
12.
Your pressure washer is ready for use.
PROPER CONNECTION TO THE DRINKING WATER NETWORK
Comply with the requirements of the local water provider. According to the Rule DIN 1988, the device must be
only connected to the network supply of drinking water if the retention valve, to prevent water reverse flow with
drainage resource, is installed in the water inlet hose. Set the quick hitch in the water supply hose (quick hitch
not provided).
Fit the quick hitch of the hose in the machine terminal and connect in the water supply.
LENGTH AND QUALITY OF THE WATER SUPPLY HOSE
The device can be directly connected to the pipes supplying drinking water only if the supply hose was provided
with a retention valve to prevent water reverse flow according to the current legislation. Make sure the hose has
at least Ø13mm and it is strengthened, with a maximum length of 30 meters. Schulz recommends the installation
of the Retractable Reel Line with a 10-meter, 20- meter or 30-meter hose.
8. INSTALLATION