64
►
Close the maintenance hatch.
►
Switch the mains power back on.
►
Select any washing programme and
end it immediately as soon as the wa-
ter inlet stops. This procedure prevents
detergent from flowing unused into the
drainage system at the next wash.
Cleaning the filters in the
water inlet
The filter in the water inlet may get
plugged.
Check and clean the filters if:
►
The error message
Check water
inlet
appears.
►
Insufficient water flows into the appli-
ance when the tap is turned on.
Notice
Decrease the pressure in the inlet hose
before unscrewing it:
►
Turn the water tap off.
►
Select any programme, start it and
end it again after approx. 40 seconds.
As a result, the water pressure in the
inlet hose can be reduced.
►
Switch off the power supply.
►
Screw off the supply hose at the tap.
►
Rinse out the filter under running
water.
►
Connect the hose again.
►
Unscrew the other end of the hose
from the back of the machine.
►
Pull out the filter using a pair of lomg
nose plier and rinse it out under run-
ning water.
►
Reinsert the filter and connect the
hose again.
►
Briefly turn the water tap on and make
sure that no water escapes.
►
Turn the water tap off.