EN
Connection
Directions for use for the power pack
51
DANGER
Electric shocks are possible from incorrect correction of
the power pack.
Electric shocks can lead to severe or deadly injuries.
Make sure that only qualified electricians connect
the LIPROTEC-System to the mains voltage.
Before all work, make sure the mains cable is not
live.
Do not connect the power pack to the mains
connection until all work has been concluded.
Close all coverings on the power pack after work.
6.1
Connection variants
The components of the LIPROTEC system can be assembled
and connected in the following combinations:
One or more LED strips (LTES1 through LTES6),
connected to a power pack with an upstream light switch
(see the "Directions for use of the LED strip," Fig. F)
One or more LED strips (LTES1 through LTES6,
LTES9), connected to a receiver for remote control, with
an upstream power pack and optional light switch (see
the "Directions for use of the LED strip," Fig. E)
