EN
Connection
52
Directions for use for the power pack
One or more LED strips (LTES1 through LTES6,
LTES9), connected to a building automation system,
which assumes the power supply and control (see the
"Directions for use of the LED strip," Fig. G)
The connection possibilities applicable for the existing
component are described in the following.
If you connect the LED strips directly to the
power pack, you should have an on-site light
switch at the power pack’s 230 V connection so
that the light can be turned “on” and “off” on site
However, it is not possible to control the
brightness levels of the connected LED strips in
this combination. Details regarding the
connection to the on-site light switch can be
found in the respective documentation of the
external components.
With a LIPROTEC Bluetooth receiver, you can
control the brightness and colour of the LED
strips depending on the type and switch them
“on” and “off”. However, we still recommend that
you use an on-site light switch to optimise ease
of use.
