Schuler HF255, Operator'S And Service Manual, Page: 34 / 68

- 2 -
SAFETY AND OPERATIONAL DECALS
SAFETY AND OPERATIONAL DECALS
SAFETY DECALS ARE PLACED ON THE MIXER/FEEDER FOR THE PROTECTION OF THE
OPERATOR OR ANY PERSON NEAR THE UNIT.
Be sure everyone who operates this equipment understands all the information, warning, caution, and
danger decals.
Keep the decals CLEAN so they are readable. This applies to all caution, warning, and danger decals.
It is the OWNER’S RESPONSIBILITY to provide information for safe operation of this machine.
Replace any damaged or worn decals. Once any part of a decal becomes non-readable, it should be
replaced. The part numbers for the decals are located in the lower RH corner of the decal, and listed in
this manual on the following pages. Replacement decals may be ordered through your dealer or the
address below.
When replacing decals, be sure the surface area is clean and dry, peel the backing off the decal, and
apply to the machine. Be sure to wipe with a clean cloth to rub out all air bubbles to assure a good
seal. For best adhesion, decals should be applied in temperatures of 50 degrees (F) or warmer.
DECALS
ITEM QTY PART NUMBER DESCRIPTION
1 1 10010-0210 DECAL, DANGER, PTO, ROTATING DRIVE LINE
2 3 10010-0220 DECAL, DANGER, IF YOU CAN READ THIS, THE SHIELD IS NOT IN...
3 1 10010-0225 DECAL, DANGER, DO NOT USE THIS SHIELD FOR STEP
4 4 10010-0310 DECAL, WARNING, KEEP AWAY MOVING PARTS... (ARM IN RC)
5 5 10010-0317 DECAL, WARNING, KEEP OUT MOVING PARTS, FAILURE TO HEED...
6 1 10010-0421 DECAL, IMPORTANT, READ OPERATORS MANUAL, OPERATOR
7 1 10010-0500 DECAL, SLOW MOVING VEHICLE
8 3 10010-0920 DECAL, RED REFLECTIVE TAPE, 2 * 9 (REFLEXITE)
9 2 10010-0921 DECAL, YELLOW REFLECTIVE TAPE, 2 * 9 (REFLEXITE)
10 2 10010-0323 DECAL, WARNING, ROTATING PARTS, DISENGAGE POWER
6 10010-0522 DECAL, GREASE GUN, 50 HOURS
1 10010-0610 DECAL, IMPORTANT, USE 300-400 PTO RPM, MACHINE MUST BE...
1 10010-0611 DECAL, IMPORTANT, MANUAL INSIDE SHIELD
1 10010-0615 DECAL, IMPORTANT, DO NOT OPERATE MACHINE W/CONVEYOR...
1 10010-0631 DECAL, IMPORTANT, TIGHTEN FLOOR CONVEYOR SO TIGHTENER..
1 10010-0661 DECAL, IMPORTANT, A SPECIAL SHEAR KEY FOR FLOOR APRON
1 10010-0664 DECAL, IMPORTANT, TIGHTEN WHEEL LUGS
1 10010-0730 DECAL, FLOOR SPEEDS, FOR RATCHET DRIVE UNITS
1 10010-0750 DECAL, MANUAL BRACKET SERIAL NO. IF MANUAL IS MISSING...
1 10010-0100 DECAL, SCHULER, QUALITY BUILT, TDC
3 10010-0101 DECAL, SCHULER, 4 * 20, TDC
1 10010-0161 DECAL, MODEL, 'HF255', TDC
1 10010-0163 DECAL, MODEL, 'HF295', TDC