G
B
1
9
The position of the corresponding gas burner or
electric hotplate* is shown on every knob.
G
as
b
u
rners
Each burner can be adjusted to one of the following
settings using the corresponding control knob:
Off
Maximum
Minimum
To light one of the burners, hold a lit match or lighter
near the burner and, at the same time, press down
and turn the corresponding knob anti-clockwise to the
maximum setting.
Since the burner is fitted with a safety device, the
knob should be pressed for approximately 2-3
seconds to allow the automatic device keeping the
flame alight to heat up.
When using models with an ignition button, light the
desired burner pressing down the corresponding
knob as far as possible and turning it anticlockwise
towards the maximum setting.
If a flame is accidentally extinguished, turn off the
control knob and wait for at least 1 minute before
trying to relight it.
To switch off the burner, turn the knob in a clockwise
direction until it stops (when reaches the position).
T
h
e
"
d
o
u
b
le-
f
la
m
e
" b
u
rner
*
This gas burner consists of two concentric flame
rings. Using both flame rings enables a higher
power level to be reached, thus reducing cooking
time with respect to the time required by traditional
burners. The double ring also enables heat to be
distributed across the base of the pan more evenly.
Cookware of all sizes may be used; when cooking
with small recipients use only the inner burner. The
burner is controlled with a single knob.
To light it, press the knob in fully and turn it in an
anticlockwise direction until it reaches the maximum
position
. The burner is equipped with an
electronic lighting system that is activated
automatically when the knob is pressed.
A
s
t
h
e
bu
rner
i
s f
itte
d w
it
h
a
s
a
f
et
y d
e
v
ice
,
the
knob should be held down for approximately 2-3
seconds, until the automatic device keeping the
flame alight has heated up.
Each burner can be adjusted using the control knob
as follows:
Off
On and inner ring set to maximum
Inner ring set to minimum
Both rings set to maximum
Both rings set to minimum
To switch off the burner, turn the knob in a clockwise
direction until it stops (when it reaches the
position).
C
era
m
i
c
G
lass
M
o
du
le
*
This cooktop is fitted
with dual-ring radiant
heating elements
located beneath the
glass. It is possible to
turn on only the circular
part of the elemement
(identified by the letter
"
A
") or the cooking
surface can be
enlarged by turning on
both "
A
" and "
B
". To
turn only the circular "
A
" element, simply turn the
knob in the clockwise direction to any one of the 12
available settings. To add the "B" section, turn the
knob to setting 12 and then click it into the
setting. Then proceed by turning the knob in the
counter-clockwise direction to one of the 12
settings.
The figure shows the heating zones, which become
red when the element is turned on.
A. Circular heating zone;
B.Extended heating zone;
C.Indicator light to show when the cooking zone is
above 60°C, even after the heating element has
been turned off.
When the knob is on any of the settings other than
"Off", the Indicator Light for Ceramic Glass Module
comes on.
S
tart
-
up
and
use
*
Only available on certain models.
A
C
B
