28
2. INSTALLATION
2.1 Electrical connection
This equipment must be connected to a grounding plant. Two types of electrical
connection can be used:
1.
Using a standard plug to be connected to the power cable and inserted in a mains
socket which must be accessible (so that the plug can be disconnected when servicing
is carried out). Make sure that the plug is accessible also after the complete installation
of the equipment.
2.
By means of a fixed mains connection, fitting a bipolar switch, which ensures
the disconnection, with an opening distance of the contacts allowing a complete
disconnection on the conditions of the overvoltage III category, according to installation
regulations. The ground connection (yellow-green wire) must not be interrupted.
Refer to the rating plate inside the hood for the mains voltage and frequency ratings.
If the power cable is damaged, it must be replaced by the manufacturer or by its service
agent or a qualified person in order to avoid any risk.
2.2 Filtration modes
This cooker hood can be employed as evacuation or recycling.
Evacuation :
Kitchen smokes are driven outside through a flue joined to the exhaust pipe
flue connector. This pipe must not under any circumstances be connected to cooker, boiler
or burner exhaust pipes, etc.
Recycling :
Smokes pass through the activated charcoal filter to be cleaned and recycled
in the kitchen environment by means of holes from which the purified air will come out.
These holes must be free and communicating with the kitchen environment.
Charcoal filters should not be implemented when using evacuation installation .
2.3 Installation
Read the instruction manual before installing and/or using the hood.
The unit must be fitted at a distance of at least 65 cm from the cooking hob. If the
mounting instructions of the gas cooker indicate a wider distance, respect it.
Respect all the air discharge regulations.
The air must not be discharged in a pipe used to discharge exhaust fumes produced by
gas-fed equipment or fuel-fed equipment (this does not apply to filtering hoods).
Fitting the hood (fig. 4)
1.
Assemble the cooker hood with the help of the assembly scheme.
2.
Fix the assembly pattern on the wall, at the specified height (see the minimum and
maximum distances intended for the worktop, in the assembly pattern). Perforate points A,
B and C.
(Fig. 4)
Summary of Contents for SOHT1910X
Page 3: ...3 FIG 1 Schéma technique Technical drawing ...
Page 21: ...21 ...
Page 35: ...1 1 Scholtes com 2020_07 ...
