II/ 12
FSP
GB
*For troubleshooting: refer to the information in the "Technical data" chapter in part 1 of the instruction manual!
If necessary, contact our service staff, see last page.
E
Material accumula-
tion concentrated in
the middle
Too much material application
X
Use smaller nozzle set Reduce
paint quantity (item 03):
Decrease material pressure
(item 18):
Working pressure (flow pres-
sure) too low
X
Increase working pressure (flow
pressure) Observe maximum
working pressure
*
Viscosity is too high
X
Decrease viscosity or increase
material pressure (item 18)
F
Spray pattern
moved to one side
Dirty or deformed holes on the
flanges of the air cap
X
Clean (see Chapter 4, 5) or re-
place complete nozzle set
(item 10, 11, 12 or 13) (see
Figure 3a-c)
Problem
Cause
Remedy
