Instructions for Use
– SCHMIDT
®
Flow Sensor SS 20.700
Page 31
Transport / Shipment of the sensor
Before transport or shipment of the sensor, the delivered protective cap
must be placed onto the sensor head. Avoid contaminations or mechani-
cal stress.
Calibration
If the customer has made no other provisions, we recommend repeating
the calibration at a 12-month interval. To do so, the sensor must be sent
in to the manufacturer.
Spare parts or repair
No spare parts are available, since a repair is only possible at the manu-
facturer's facilities. In case of defects, the sensors must be sent in to the
supplier for repair.
A completed declaration of decontamination must be attached.
The appropriate form “Declaration of decontamination” is enclosed with
the sensor and can also be downloaded from
under the heading “Service & Support for Sensors”.
Alternatively it can be downloaded from
under the heading "Service & Support für Sensor
ik”.
If the sensor is used in systems important for operation, we recommend
you to keep a replacement sensor in stock.
Test certificates and material certificates
Every new sensor is accompanied by a certificate of compliance according
to EN 10204-2.1. Material certificates are not available.
Upon request, we shall prepare, at a charge, a factory calibration certifi-
cate, traceable to national standards.
