Schmidt AmphiBlast 120, Operation And Maintenance Manual

Page: 28 / 116

28
Copyright © 2019 Axxiom Manufacturing, Inc.
The function of the Schmidt® Bulk AmphiBlast™ is to provide a mixture of wet abrasive and
compressed air to a blast nozzle. The abrasive blast stream through the blast nozzle is used for
removing rust, paint, or other unwanted surface defects. After abrasive blasting, the surface is washed
off and blown dry before it is ready for new paint or coating.
A Bulk AmphiBlast™ is one of a group of components used in an abrasive blasting job. The typical
components are an air compressor, moisture removal device, an abrasive blaster, blast hose, a blast
nozzle, operator personal protective equipment, and blast abrasive. See Figure 4.1.
The blast abrasive is loaded into the abrasive blaster through the abrasive inlet at the top of the blaster.
All the compressed air must be removed from inside the abrasive blaster before it can be filled with
abrasive. The abrasive can be bag loaded, or loaded from a Schmidt storage hopper. To begin blasting,
the abrasive inlet is closed and the abrasive blaster is filled with compressed air from the air
compressor. Since moisture creates problems in the blast operation, it is common for the compressed
air to be fed through a moisture removal device, such as a Schmidt AirPrep System. The air pressure in
the abrasive blast vessel is equal to the air pressure in the blast hose where it connects at the metering
valve. This equal pressure is needed to allow the blast abrasive to flow downward by gravity. The
abrasive flow is controlled by the metering valve at the bottom of the blaster. From the metering valve
the blast abrasive flows into the blast air stream where it is injected with water. The mixture of wet
abrasive and air then flow through the blast hose. The speed of blast air and wet abrasive mixture is
greatly increased by the blast nozzle onto the work surface. The high speed of the air and abrasive is
what gives it the energy to blast rust and paint off of surfaces. Even though wet blasting greatly reduces
the amount of dust produced during blasting, there can still be a small amount of dust that is harmful;
therefore, all blast operators must use personal protective equipment during the blast operation.
All the components required for the blast operation (except for the air compressor) are available from
Axxiom Manufacturing, Inc. Call Axxiom to locate a distributor.
Figure 4.1
– Typical Bulk Abrasive Blast System
4.0 Abrasive Blast System General Operation