Schmalz SMPi 20, Operating Instruction, Page: 6 / 50

S
CHMALZ
SCP
I
/ SMP
I
2-6
2 S
TART
-
UP
Installation and operation
For safe installation and smooth operation, please observe and maintain the following
points:
The ejector may only be operated via power supply units with protected
extra-low voltage (PELV). The system must incorporate safe electrical cut-
off of the power supply in compliance with EN60204.
The device may not be operated in environments where there is a risk of
explosion.
Risk of fire and explosion.
The device may not be operated outside its specified capacities.
Doing so may either cause the device to malfunctions or destroy the device.
During installation and maintenance, make sure that the ejector is disconnected
and depressurised and that it cannot be switched on again without authorisation.
Personal injury or damage to the ejector may otherwise occur.

Protect the ejector from being damaged at all times.

No modifications may be made to the ejector.

Exclusion of warranty if X-Pump has been opened by the customer.

Connection symbols and designations are located on the ejector.
These must be observed.

Only the intended connections may be used.

Pneumatic and electrical line connections must be securely connected and attached to
the ejector.

The ejector may be installed in any position.

If these notices are not observed, then malfunctions, material damage and serious injury
– including fatal injury – could occur as a result.

If the ejector is no longer operative, the components must be disposed of in an ecologi-
cally sound manner.