Schlage LE162, Installation Instructions & User Manual

Page: 23 / 28

21
TROUBLESHOOTING
Problem Lights/
Beeps Cause Solution
at Lock
Entering a valid user
code using the keypad
does not unlock lock Green then
Red/High
then Low Lock is in vacation mode Enter six-digit programming
code
Buttons do not light up
when pressed None Lock keypad is locked out
because too many incorrect
codes have been entered Wait 30 seconds and try
again
Battery is dead Replace battery. See
Replacing the batteries
on page 16
There is a delay before
the lock unlocks after
a valid user code is
entered Red then
Green/
Low then
High Battery is low Replace battery. See
Replacing the batteries
on page 16
The led light blinks red,
even when no buttons
have been pressed Fast red
blink Battery is critically low Replace battery. See
Replacing the batteries
on page 16
Cannot add a new
user code Red (when
attempted
via keypad) 19 user codes already exist Delete at least one existing
user code. Then add new
user code
When adding a user at the
keypad, the first user code
entry did not match the re-
confirmed user code entry
Try again. Make sure you
enter the same code twice
New user code matches first
four digits of the programming
code
Change the programming
code or select a different
user code to add
User code already exists in lock Select a different user code
Cannot delete a user
code at the keypad Red The first user code entry did
not match the re-confirmed
user code entry
Try again. Make sure you
enter the same code twice