Schiller Grounds Care RYAN MATAWAY 544283B, Operator'S Manual

Page: 27 / 54

25
MATAWAY
SERVICE
5. Remove the input shaft A , output shaft B and
spacer C . Also remove the bearings D and
grease seals.
6. Install new bearings into both case halves.
DO NOT install new grease seals at this time.
INPUT SHAFT
7. Remove large double gear E , small gear F , key
G , and spacer H from input shaft J .
8. Check the input shaft for wear and replace if
necessary (if shaft needs to be replaced, install
the existing snap ring K on new shaft). If the
shaft is NOT replaced, remove any burrs from
keyways and/or shaft ends if necessary.
9. Replace bushings in the large double gear E
(or replace gear if necessary). When replacing
bushings, make sure they are flush with the edge
of the gear and that the oil holes on gear are
aligned.
10. Install the spacer H onto shaft against the snap
ring K . Install the large double gear E , with the
small gear side against the spacer.
11. Install key G into keyway and slide the small gear
F (flat side toward the larger gear) onto the shaft.
OUTPUT SHAFT
12. Remove large gear L , large double gear M and
key N from shaft P . Check the shaft for wear
and replace if necessary (if shaft needs to be
replaced, install the existing snap ring O on new
shaft). If the shaft is NOT replaced, remove
any burrs from keyways and/or shaft ends if
necessary.
13. Replace bushings on large double gear M (or
replace gear if necessary). When replacing
bushings, keep the bushings flush with the
edge of the gear. Be sure oil holes on gear are
aligned.