23
MATAWAY
SERVICE
10. Reinstall the locking collar against the
bearing. Tighten locking collar by rotating
counterclockwise on pillow block shoulder. Using
punch and hammer, lock collar into position.
Tighten set screw.
11 Adjust the pillow block up and down until it is
centered on the shaft. Tighten the pillow block
hardware.
12. Rotate the drive shaft by hand to make sure there
is no side load.
NOTE
: Excessive side load on the shaft may cause
engine crankshaft failure.
13. Check the reel belt pulley alignment. The
measurement
A
should be 5/8" (16mm). If
adjustment is required, loosen the set screw in
the pulley and move the pulley in or out on the
shaft.
NOTE
: The pulley is secured to the shaft by set
screw and key. It may need to be tapped with a
hammer for adjustment. Use a plastic, rubber, lead
or leather head hammer to avoid damaging the
pulley.
14. Support the unit on jack stands and reinstall the
reel and belt guard beneath the chassis.
Use adequate jack stands when supporting
the unit. Failure to do so may result in
personal injury.
NOTE
: Belts should be tight when the reel and drive
are engaged and loose enough to slip when they are
disengaged.
Summary of Contents for RYAN MATAWAY 544283B
