Schiller Grounds Care Bob-Cat 942311F, Operator'S Manual

Page: 34 / 70

32
FastCat RZ
DECK LEVELING
1. Park the machine on a smooth, level surface.
Raise the deck to the transport position.
2. Lower the deck onto a set of equal height blocks
under the rear corners of the deck. Place an-
other set of blocks under the front of the deck so
that the deck top is pitched forward 1/8".
NOTE: The front and rear of the deck are at different
heights.
3. Measure the height of the blade cutting edge
above the ground. Remove pin B and set the
height of cut lever E to that height
4. Loosen nuts on bolts G . Move bolts in slot to
remove slack in chain. Tighten nuts on bolts G .
ADJUSTMENTS
HEIGHT OF CUT
The height of cut is set by moving height of cut pin B
to the hole designated for the height of cut desired.
To change the height of cut:
1. Lift the deck to the highest position.
2. Move pin
B to the selected hole.
3. Lower the deck until the lift lever is stopped by
the pin.
NOTES :
- Height of cut may vary due to the amount of
tread on the tires, tire diameter or inflation pres
-
sure.
DECK ROLLERS
The deck rollers are adjustable up and down to
provide improved deck flotation and scalping protec
-
tion at various heights of cut. They are not intended
to ride continuously on the ground. Adjust no closer
than 3/8" (10mm) to the ground.
Height of cut ranges for roller adjustment