11
Classic
Pro
HEIGHT OF CUT
Make all adjustments with the engine shut off, spark
plug wire disconnected and mower drive disengaged.
The cutting height is determined by the position of
the blades in relation to the wheels. Variation to this
height may be made at TWO points. (See HEIGHT
OF CUT CHART on page 12.)
1. THE AXLE POSITION
1. Support the rear of the unit with jackstands
or other suitable means.
2. Remove brake rod
R
from bellcrank
Q
.
3. Remove (4) bolts
M
, (2) washers
K
and
(4) nuts
L
.
4. Place the axle
J
in the desired position
according to the Height of Cut Chart on page
12.
5. Install the bolts, washers and nuts removed
in step 3.
NOTE:
Install the washers
K
on the bolts in the slots.
6. Install the brake rod
R
onto bellcrank
Q
.
7. Adjust brakes and belt guide
V
as shown in
the ADJUSTMENT section.
2. THE CASTER WHEELS
1. Remove the quick pin
P
from the top of the
caster wheel pivot spindle.
2. Place required spacers above or below
wheel support bracket and replace the quick
pin
P
.
