Automatik-Kabelaufroller FT / FTE 260 / EFT 265
* automatic cable rewinder FT / FTE 260
/
EFT 265
Montage- und Bedienungsanleitung *
installation and operating instruction
467550000 Bedienungsanleitung FT_FTE 260-
EFT 265
22.10.2019
Schill GmbH & Co. KG, Bruckstraße 44, 70734 Fellbach
Seite 10
LOCKING DEVICE
CONNECTING THE CABLE REEL
EXTENSION CABLE
THERMAL SAFETY GUARDS
In order to avoid an overheating of the cable reel, depending of
the product version varying safety methods are used.
• The maximum payload is reduced by a 10A special glass
bulb fuse. In the single-phase version, the phase is fused.
On the three-phase versions all three phases are fused.
The glass tube fuse is seated in the terminal block.
• If the use of 16A is relevant a self-retaining thermal switch for
the single-phase versions can be implemented. If activated
the power supply will be cut out. The power supply can be
re-started by pressing the button after a cool down time.
• The nominal current can be reduced by a 10A fuse within the
distribution box.
The included standard cables are designed to tolerate the weight of the pulled-out cable including the cable stopper. Additional
weights are not allowed. The mounted cables are limited to the specified lengths. Never use excessive force to unwind the cable as
this can damage both the cable and the reel. Should the cable be blocked while coiling up, please pull the cable out again and recoil.
Attention should also be paid to section „GENERAL" and “CONTINOUS OPERATION".
In the case of versions without pull-out cables, the cable is connected as described under "EXCHANGING THE PULL-OUT CABLE”.
As a standard feature the cable reel has a disengageable cable locking
device. The latching mechanism ensures that the pulled-out cable stays
without traction fixed in place. When the cable is being pulled out, the spring
detent passes over a series of grooves. An audible click indicates that the
locking device is engaged. If you gently rewind the cable after the clicking
sound, you will notice that the spring detent will engage into the notches,
locking the cable in position. The cable can be disengaged by gently
continuing to pull the cable until the click can no longer be heard. The
tensioned spring will pull the cable back onto the reel.
The locking device
FT / FTE 260
can be disengaged by pulling the knurled grip out by approx. 1 cm and turning it between 90° and
180°. This will disengage the locking device the cable is then constantly under tension.
ATTENTION
Do not release the cable when rewinding, the tension of the spring can accelerate the winding speed to such a degree
that the swinging able end could cause injury. Also damage to the cable and spring could be the result of such an
action.
The cable reels are unless otherwise agreed supplied without connection
cable. The connection cable can be mounted in a individual length to the
internal fuse terminal according to the sketch above.
ATTENTION
Make sure the yellow / green earth wire is connected to the fuse
terminal marked with the grounding mark and the strain
relief is tightened.
LOAD
Please refer to the details on the product label or if the cable is fitted by yourself, please adhere to the details supplied by
DIN EN 50565-1 regarding the performance of the used cable.
