Automatik-Kabelaufroller FT / FTE 260 / EFT 265
* automatic cable rewinder FT / FTE 260
/
EFT 265
Montage- und Bedienungsanleitung *
installation and operating instruction
467550000 Bedienungsanleitung FT_FTE 260-
EFT 265
22.10.2019
Schill GmbH & Co. KG, Bruckstraße 44, 70734 Fellbach
Seite 12
EXCHANGING THE SPIRAL SPRING
INSTALLATION HEIGHT
FITTING INSTRUCTIONS
Wall installation with universal holder DWB 260
The installation height of the cable rewinder is not limited. The maximum extension length is the specified cable length. The standard
cables are designed to withstand the weight of the extended cable included cable stopper. Additional tensile forces (cause by additional
weights for example) are not permitted.
When the cable is pull-out horizontally due to the weight of cable a slack occurs. This is about 10% of the cable pull-out length.
• Disconnect the cable reel from the power supply and remove from the operation site.
• Remove the cover for the connecting terminals.
• FT / EFT
disconnects the stranded wires of the upper slip ring from the fuse terminals.
FTE
disconnect the stranded wires of the
upper slip ring from the hexagon screw.
• Loosen all the screws and remove the housing cover.
ATTENTION
The spiral spring in the coil is under tension. Please ensure that the locking mechanism is activated.
• Carefully pull the upper slip ring off the plastic axle.
• To replace the spiral spring, you should make sure the spring is unwinding for your own safety! Please adhere to the following
instruction:
1. Carefully pull on the cable stopper until the click of the notches have faded, you immediately notice a pull on the cable
stopper in the opposite direction.
2. Let the coil run back slowly and count the number of turns. This is important to adjust later the exact preload on the
spring again, without damage to coil or spiral spring. In the end the coil should be able to move freely.
• Turn the drum and release the coil from the housing by undoing the centre screw.
• Put the coil on the side with the spring cover disc top. Remove the spring cover disk.
• Remove the plastic axle.
• Remove the defective spring.
• Carefully re-assemble the coil. Undertake the Re-assembly in reverse order (see “TIGHTENING TORQUE”).
• If necessary, wind down the pull-out cable completely by turning the coil and insert the new spring.
Pay attention to the
installation position!
• Insert the new spring.
Pay attention to the installation position!
ATTENTION
Due to the manufacturing design the spring is under tension and could unwind very fast and cause injuries if handled
improper.
• Reinsert the plastic axle and assemble the spring cover disc. Ensure the retainer pin is engaging the spring eye.
• Adjust the pre-load: Hold the stopper outside the housing and hold it with one hand. Now turn the coil as often as you counted. At
the end let it snap into the notches (see "LOCKING DEVICE").
• After the complete re-assembly undo the locking. Pull on the cable stopper, wind out the cable complete and slowly rewind it.
• Before re-mounting at the operation area, please check for a correct performance (see “READY FOR USE”).
The cable reel can be rotated 150°.
PLEASE NOTE
The cable reel housing must be pushed onto the universal holder pin, then
insert the slider into the intended position of the cable reel housing.
