Magnetic Drilling Machine
Operating Manual
6 Start bringing the twist drill to the workpiece but handle with care and do not
apply too much pressure. The drill has to find its way in to the material by
itself. It is not necessary to use a lot of pressure. Too much pressure will cause
damage and breakage.
5 Start the motor by pressing the green motor start button.
7 After the cutting is finished switch the machine off by pushing the red button.
WARNING: THE SLUG WILL BE EJECTED AND IS VERY HOT
4 Apply cutting oil to the twist drill and workpiece. Always use cutting oil from
your dealer.
Also twist drills with a direct Weldon connection are available
5.3 Drilling with twist drills
- Adapter 19 mm Weldon – B18 taper connection
- Adapter 19 mm Weldon – B16 taper connection
There are several accessories available to be able to use twist drills with your
magnetic drill.
These adapters will allow you to attach a drill chuck on to the hole cutter arbor.
- Adapter 19 mm Weldon - ½”x20 UNF
(ranging from Ø 6 – Ø 12 mm)
1 Place the machine at the desired position
2 Switch on the magnet
3 Ensure that the magnetic drilling unit is secure on the working piece.
12
SWC 35 AT
Drill Chuck
Weldon Drill Chuck Adaptor