Magnetic Drilling Machine
Operating Manual
9. SWC 35 AT is equipped with over load protection, machine stops
automatically sensing over load avoiding cutter breakages.
6. Fig. A depicts machine in manual mode. Bring handle lever down, once the
pilot pin touches the surface, push the handle lever as shown in fig. B to
initiate in automatic feed mode.
8. Let machine reverse automatically to its original position in order to get
grease rotate and motor to cool down.
7. Once the hole is drilled the machine will automatically reverse to its original
position and stop automatically.
10. If the slug gets stuck in the cutter, move the machine to a flat surface. Switch
on the magnet and gently bring the cutter down in contact with the surface.
This usually allows a slug to straighten and to eject.
11
SWC 35 AT
Manual
Mode
Auto
Mode
Fig. A
Fig. B