5 Start the motor by pressing the green motor start button (I).
3) Put the cutter or adapter in the arbor, making sure the flat sides are
exactly in front of the arbor retaining screws.
5) Check if the center pilot can move inside the cutter (up and down).
1) Make sure the machine is disconnected from the power supply.
3 Ensure that the magnetic drilling unit is secure on the working piece.
2) Put the center pilot in the cutter hole.
5.2 Drilling with Core Drills
5.1 How to mount tools or adapters in a Weldon arbor?
4) Tighten the retaining screws.
CAUTION :
For 100% magnet clamping force you need at least 10 mm of steel.
Coatings, paintings and dirt between magnet and workpiece will affect clamping
force.
2 Switch on the magnet.
1 Place the machine at the desired position
4 Fill the arbor with lubrication/cutting oil in the special meant holes. Always
use cutting oil from your dealer.
Magnetic Drilling Machine
Operating Manual
OPERATING MANUAL
3
7
10
SWC 35 AT