Scheppach TS82, Translation Of Original Operating Manual

Page: 30 / 48


www.scheppach.com

service@scheppach.com

+(49)-08223-4002-99

+(49)-08223-4002-58
30 І 48
Such damaged electrical connection cables must not
be used and are life-threatening due to the insulation
damage.
Check the electrical connection cables for damage regu-
larly. Make sure that the connection cable does not hang
on the power network during the inspection.
Electrical connection cables must comply with the ap-
plicable VDE and DIN provisions. Only use connection
cables with the marking „H05VV-F“.
The printing of the type designation on the connection
cable is mandatory.
Troubleshooting
Problem Possible Cause Help
1. Saw blade gets
loose after turning
off the motor
Fastening nut tightened insufficiently Tighten fastening nut
2. Motor does not start a) Failure mains fuse a) Check the mains fuse.
b) Extension cable defect b) Change extension cable
c) Connections to the engine or
switch out of order
c) Have it checked by an electrician
d) Connections on the motor or switch
defect
d) Have it checked by an electrician
3. Motor reverse
rotation
a) Capacitor defective a) Have it checked by an electrician
b) Incorrect connection b) Then switched by a qualified electrician polarity of the
wall socket
4. Motor does not
perform, the fuse
responds
a) Cross section of the extension
cable insufficiently
a) see electrical connection
b) Overload by dull saw blade b) Change saw blade
5. Burns on the cutting
surface
a) dull saw blade a) Change saw blade
b) Wrong saw blade b) Change saw blade
AC motor
• The mains voltage must be 230 V~
• Extension cables up to 25 m long must have a cross-section
of 1.5 mm
2
.
Connections and repairs of electrical equipment may only be
carried out by an electrician.
Please provide the following information in the event of any
enquiries:
•
Type of current for the motor
•
Machine data - type plate
• Motor data - type plate