Scheppach ts 30, Original Instructions Manual

Page: 45 / 214

45
Troubleshooting table
Warning: In the interests of operational safety, always switch off the saw and remove the mains plug before carrying out maintenance
work.
Problem Possible Cause Help
Saw blade gets loose after
turning off the motor
Fastening nut tightened insufficiently Tighten fastening nut, M20 left-handed thread
Motor does not start a) Fastening nut tightened insufficiently
b) Extension cable defect
c) Connections on the motor or switch defect
a) Check the mains fuse.
b) See “Electrical Connection” in the operating
manual
c) Have it checked by an electrician
No motor output turns off
automatically Overload by dull saw blade, thermoprotection is
triggered Insert a sharpened saw blade; motor can be
turned on again after the cooling period
Burns on the cutting
surface
c) with longitudinal cuts
d) with cross cuts
a) Fastening nut tightened insufficiently
b) Wrong saw blade
c) Longitudinal stop not parallel
d) Slide carriage not parallel
a) Insert a sharpened saw blade
b) Insert saw blade with 20 or 28 teeth for
longitudinal cuts
c) Exchange the longitudinal stop
Align the slide carriage with the saw blade