Scheppach Molda 5.0f, Translation From Original Manual

Page: 35 / 100

Page 35

Only use the machine if it is in a technically fully functional state. Pay attention to the intended use, safety
and potential dangers and comply with the operating instructions! Immediately repair any malfunctions
that may affect safety, or have them repaired.

The safety, working and maintenance instructions and the dimensions stipulated in the specifications
must be observed.

The applicable regulations for the prevention of accidents and other generally recognized safety rules
must be observed.

The machine may only be used, maintained or repaired by trained persons who are familiar with the
machine and have been instructed about the dangers. The manufacturer shall not be liable for any
damage resulting from unauthorized modifications of the machine.

The machine may only be used with original accessories of the manufacturer.

Any other use is considered to be not intended. The manufacturer shall not be liable for any damages that
may result from such use. Such risk is borne exclusively by the user.
Residual risks
The machine has been constructed according to current technical standards and recognised safety rules.
Nevertheless, single residual risks may occur during operation.

The rotating cutting tool may cause injury to fingers and hands if the workpiece is not guided in the proper
manner.

Injury may be caused by a spinning workpiece if you work using inadequate support or guidance, for
instance by working without a fence.

Danger to health from sawdust or wood shavings.

Always wear personal protection equipment as well as goggles and a dust mask. Use the suction device!

Health hazard from excessive noise. The permissible noise level is exceeded when working with the
machine. Always wear personal protection equipment such as ear protection.

Danger from electric current if incorrect electrical connecting cables are used.

Only machine selected wood without flaws such as: knots, lateral cracks, surface cracks.

Wood that contains flaws can pose a risk when worked.

Risk of injury from defective cutting tools. Check the tools regularly to ensure they are intact.

Additionally, non-obvious residual risks may exist in spite of all measures taken.

Residual risks can be minimised by carefully observing the “ Safety instructions ” and the “ Intended use ”
as well as the entire operating instructions.
Scope of delivery
Molda 5.0f Spindle Moulder
Curved moulding guard complete
with suction connector
Article no. 7231 0019
Moulding fence complete with
overhead roller guard assembly
Article no. 7210 5000
Spindle bushing, 2 pcs 0,5 mm long Article no. 3301429011
Spindle bushing, 2 pc. 5 mm long Article no. 3301429010
Spindle bushings, 2 pc. 10 mm long Article no. 3301429009
Spindle bushing, 1 pc. 15 mm long Article no. 3301429008
Single-head wrenches, 1pc. SW 41 Article no. 0108 9413
Allen key SW10 Article no.
Suction connector Article no. 7500 3800
Accessory bag
Operating instructions
Accessories: page 28