28 | GB
www.scheppach.com /
+(49)-08223-4002-99 /
+(49)-08223-4002-58
The printing of the type designation on the
connection cable is mandatory.
AC motor
The mains voltage must be 220 - 240 V~
Extension cables up to 25 m long must
have a cross-section of 1.5 mm
2
.
Connections and repairs of electrical
equipment may only be carried out by an
electrician.
Please provide the following information in
the event of any enquiries:
• Type of current for the motor
• Machine data - type plate
• Machine data - type plate
11.
Cleaning, maintenance, and
storage
m
Important!
Pull out the power plug before doing any
cleaning and maintenance work on the
equipment. Risk of injury from electric
shock!
m
Important!
Wait until the equipment has cooled down
completely! Risk of burns!
m
Important!
Always depressurize the equipment be-
fore carrying out any cleaning and mainte-
nance work! Risk of injury!
Cleaning
• Keep the equipment free of dirt and dust
as far as possible. Wipe the equipment
with a clean cloth or blow it down with
compressed air at low pressure.
• The two conical universal adapters (A/B)
can likewise be used for inflating air mat
-
tresses.
10.
Electrical connection
The electrical motor installed is con-
nected and ready for operation. The
connection complies with the applica-
ble VDE and DIN provisions.
The customer‘s mains connection as
well as the extension cable used must
also comply with these regulations.
Damaged electrical connection cable
The insulation on electrical connection ca-
bles is often damaged.
This may have the following causes:
• Passage points, where connection cables
are passed through windows or doors.
• Kinks where the connection cable has
been improperly fastened or routed.
• Places where the connection cables
have been cut due to being driven over.
• Insulation damage due to being ripped
out of the wall outlet.
• Cracks due to the insulation ageing.
Such damaged electrical connection ca-
bles must not be used and are life-threat-
ening due to the insulation damage.
Check the electrical connection cables for
damage regularly. Make sure that the con-
nection cable does not hang on the power
network during the inspection.
Electrical connection cables must comply
with the applicable VDE and DIN provi-
sions. Only use connection cables with the
marking „H05VV-F“.
