26 | GB
www.scheppach.com /
+(49)-08223-4002-99 /
+(49)-08223-4002-58
ards that cannot be completely ruled out.
The following potential hazards can arise
due to the type and design of the device:
• Unintentional starting up of the product.
• Damage to hearing if the stipulated
hearing protection is not worn.
• Dirt particles, dust etc. can get into the eyes
or face despite wearing safety goggles.
• Inhaling swirled up particles.
8.
Before starting the equipment
Before you connect the equipment to the
mains supply make sure that the data on the
rating plate are identical to the mains data.
• Check the equipment for damage which
may have occurred in transit. Report any
damage immediately to the transport
company which was used to deliver the
compressor.
• Install the compressor near the point of
consumption.
• Avoid long air lines and supply lines (ex-
tension cables).
• Make sure that the intake air is dry and
dustfree.
• Do not install the compressor in a damp
or wet room.
• The compressor may only be used in
suitable rooms (with good ventilation
and an ambient temperature from +5 °C
to 40 °C). There must be no dust, acids,
vapors, explosive gases or inflammable
gases in the room.
• The compressor is designed to be used
in dry rooms. It is prohibited to use the
compressor in areas where work is con-
ducted with sprayed water.
6.
Technical data
Mains connection
220 - 240 V~
50 Hz
Motor rating W
max. 1100
Operating mode
S3 15%
Compressor speed
min
-1
4300 min
-1
Operating pressure
approx. 8
bar
Theoretical intake
capacity (l/min)
approx. 180
Sound power level L
WA
97 dB(A)
Uncertainty K
WA
1.93 dB
Protection type
IP20
Protection class
II
Weight of the unit in kg
5
The noise emission values were measured
in accordance with EN ISO 3744.
Wear hearing protection.
The effects of noise can cause a loss of
hearing.
7.
Residual risks
Comply with the stipulated maintenance
and safety instructions in the operating in-
structions.
Remain attentive at all times when working
and keep third parties at a safe distance
from your work area.
Even when the device is being used proper-
ly, there will always be certain residual haz-
