12
GB
Operation
You can put the equipment into operation after you
have thoroughly read the installation and operating
instructions. Pay attention to the following points:
• Make sure that the equipment is set up securely.
•
Check that the discharge line is fitted correctly
• Make sure that the electrical connection is 230 V
• ~ 50 Hz.
• Check that the electrical socket-outlet is in good
working order.
• Make sure that no moisture or water can ever
• reach the power connection.
• Make sure that the equipment does not run dry.
Setting up the device (Fig.2)
Ensure that the specified maximum water depth shown
in Fig. 2 is not exceeded.
In the operation, the sensor (3) controls the
pumping operations. The pump starts when the fluid
level reaches the sensor. The pump switches off
automatically (depending on the ambient conditions)
when the fluid level falls below the sensor. Sensor
inserted at the top means manual function, sensor in
the other positions means automatic function.
Replacing the power cable
If the power cable for this equipment is damaged, it
must be replaced by the manufacturer or its aftersales
service or similarly trained personnel to avoid danger.
Cleaning, maintenance and ordering of
spare parts
Important!
• Unplug the power plug prior to any maintenance
• work.
• For mobile applications, the equipment should be
• cleaned with clear water after every usage.
• For stationary installation, it is recommended that you
check the floating switch for proper functioning every
three months.
•
Use a water jet to remove any lint or fibrous particles
that may have become trapped in the housing.
• Remove sludge from the shaft bottom and clean the
shaft walls every 3 months.
•
Use clear water to remove deposits from the floating
switch.
Cleaning the paddle wheel
If a lot of deposits collect in the housing, the bottom part
of the equipment must be dismantled as follows:
1. Disconnect the intake cage from the housing.
2. Clean the paddle wheel with clear water.
Important! Do not put down or rest the equipment on the
paddle wheel!
3. Assemble in reverse order.
Maintenance
There are no parts inside the equipment which
require additional maintenance.
Storing
Store the device in a dry place beyond the reach of
children. When the device is not being used, store it so it
cannot be started by unauthorised persons.
WARNING!
Do not store the device without protection outside or in a
damp environment.
Frost destroys the appliance and accessories, as
these always contain water!
Disposal and recycling
The equipment is supplied in packaging to prevent it
from being damaged in transit. The raw materials in this
packaging can be reused or recycled. The equipment
and its accessories are made of various types of material,
such as metal and plastic. Defective components must
be disposed of as special waste. Ask your dealer or your
local council.
