Scheppach 5905209901, Translation Of Original Instruction Manual

Page: 28 / 144

www.scheppach.com
28 | GB
Old devices must not be disposed of with house -
hold waste!
This symbol indicates that this product must
not be disposed of together with domestic
waste in compliance with the Directive
(2012/19/EU) pertaining to waste electrical and elec-
tronic equipment (WEEE). This product must be dis-
posed of at a designated collection point. This can
occur, for example, by handing it in at an authorised
collecting point for the recycling of waste electrical
and electronic equipment.
Improper handling of waste equipment may have
negative consequences for the environment and hu -
man health due to potentially hazardous substances
that are often contained in electrical and electron -
ic equipment. By properly disposing of this product,
you are also contributing to the effective use of nat-
ural resources. You can obtain information on collec -
tion points for waste equipment from your municipal
administration, public waste disposal authority, an
authorised body for the disposal of waste electri-
cal and electronic equipment or your waste disposal
company.
17. Troubleshooting
The table below contains a list of error symptoms and explains what you can do to solve the problem if your tool fails to
work properly. If the problem persists after working through the list, please contact your nearest service workshop.
Problem Possible Cause Remedy
Motor stops starting
Overload protection device
disengaged to protect the log splitter
from being damaged
Contact a qualified Electrician.
Fails to split logs
Log is improperly positioned
Refer to ”operation” section to perfect log
loading
Size of log exceeds the capacity of
the machine
Reduce log size before operating
Wedge cutting edge is blunt Sharpen cutting edge
Oil leaks Locate leak(s) and contact your dealer
Log pusher moves jerkily,
taking unfamiliar noise or
vibrating a lot
Lack of hydraulic oil and excessive
air in the hydraulic system
Check oil level for possible refilling. Contact
your dealer
Oil leaks around the cylinder
ram or from other points
Air sealed in hydraulic system while
operating
Loosen bleed screw by some rotations before
operating the log splitter
Bleed screw is not tightened before
moving the log splitter
Tighten bleed screw up before moving the log
splitter
Oil drain screw loose Tighten the oil drain screw firmly
Hydraulic control valve assembly
and/or seal(s) worn
Contact your dealer