Scheppach 5903405901, Translation Of Original Instruction Manual

Page: 28 / 128


www.scheppach.com /

service@scheppach.com /

+(49)-08223-4002-99 /

+(49)-08223-4002-58
28 | GB
16. Troubleshooting
The following table shows fault symptoms and describes remedial measures in the event of your machine failing to work
properly. If you cannot localise and rectify the problem with this, please contact your service workshop.
Problem Possible cause Help
Motor doesn’t start
ON/OFF switch damaged.
Replace all damaged parts before you use
your machine again.
ON/OFF cable damaged
ON/OFF relay damaged
Fuse blown
Motor burnt
Contact your local service centre. Every at-
tempt to carry out a repair, can be dangerous if
it is not done by skilled personnel.
Machine gets slower during
work.
Too much pressure put on the work-
piece.
Reduce the pressure on the workpiece.
Sanding belt comes off the
drive pulleys.
Belt does not run straight. Reset the track.
The wood gets burnt during
sanding.
Sanding disc or belt covered with
grease.
Replace disc or belt.
Excessive pressure on workpiece. Reduce pressure on workpiece.
Strong vibrations
Loosely mounted tool Tighten tool
Defective tool Change tool
Spindle knocks Repair at a Service-Station