15. Troubleshooting
WARNING
Always switch the machine off and remove the mains plug prior to all maintenance and cleaning work.
Fault
Possible cause
Remedy
Saw blade without
pins loosens after
switching off the
engine
Saw blade clamping screw (27/28) not
tightened enough
Tighten the saw blade clamping screw (27/28)
Motor does not start
Mains fuse blown
Check mains fuse
Extension cable defective
Replace the extension lead
Fine-wire fuse defective
Check the fine-wire fuse and, if necessary,
replace it with a fine-wire fuse of the same type.
Connection to the motor or switch not OK
Have this checked by an electrician
Motor or switch faulty
Have this checked by an electrician
Saw blades brake
Tension set incorrectly
Set correct tension
Load too high
Feed workpiece more slowly
Incorrect saw blade type
Use correct saw blades
Workpiece not fed straightly
Avoid lateral pressure
Saw blade oscillates,
not aligned straightly.
Holders not aligned
Open the screws that fasten the holders. Bring
the holders into the vertical position and tighten
the screws again.
www.scheppach.com /
+(49)-08223-4002-99 /
+(49)-08223-4002-58
30 | GB
