Scheppach 4901307901, Translation From The Original Instruction Manual

Page: 24 / 40

24
Trouble-shooting
Problem Possible cause Solution
1. Saw blade comes
loose after the motor is
turned off.
Mounting nut has not been tightened enough. Tighten the mounting nut (right-hand thread).
2. Motor does not start. a) Failure mains fuse a) Check the mains fuse.
b) Extension lead faulty b) Replace the extension lead.
c) Connections on motor or switch not ok c) Have an electrician check them.
d) Motor or switch faulty d) Have an electrician check them.
3. Motor has wrong
direction of rotation
a) Capacitor faulty a) Have an electrician check it.
b) Incorrect connection b) Have an electrician change the polarity of
the wall socket.
4. Motor does not have
any power, fuse is
tripped
a) Cross section of the extension lead not
sufficient
a) See Electric connection.
b) Overload due to blunt saw blade b) Replace the saw blade.
5. Burnt area on the
cutting surface
a) Blunt saw blade a) Sharpen the saw blade, replace it.
b) Wrong saw blade b) Replace the saw blade.
Storing the saw blade keys, fig. 16
The keys for saw blade replacement can be stored with
the power tool.
NOTE: Using this operating manual, check the power tool
for possible wear and tear and damage when you are
using it again.
TRANSPORT
1 Before any transport, turn the power tool off and dis-
connect it from the power supply.
2 At least two people should carry the power tool and
do not lift it by the table extension.
3 To use the transport device, put the power tool on its
side, fold up both frames and secure them by tighte-
ning the wing nut. Continue as described in Step 3.
4 Protect the power tool from blows, impact and strong
vibrations, e.g. during transport in vehicles.
5 Secure the power tool against tilting and sliding.