Scheppach 19013 04901, Translation From Original Manual

Page: 27 / 80

english 27
SW5
SW4
1
2
3
Precutting device for panel sizing circular saws
Abb. "U"
Important:
Do only use sharpened, faultless „original“ SCHEPPACH saw
blades
In case of an redounded saw balde change the table insert.
ATTENTION !
Pull power cable before changing the saw balde
1 holding mandrel
2 screw M8
• Remove the left table insert
• Put the holding mandrel (1) in the saw shaft through the
drilling in the left table half. For unfasting or fixing the
screw (2) the saw shaft will be fixed with the holding
mandrel
• Take care of the running directon of the saw blade
ATTENTION! Close protection cap (5)
Risk of damage! (Picture „L“)
Fig. "V , W , Y“
the potrusion of the scoring saw balde on the table surface
modifies to the cutting band form 1,0 – 2 mm.
With the screw (2) Fig „V“ you will do the high adjustment
1 rotation conforms 1,5mm (Fig. „Y“)
The band of the scoring saw blade will be regulated with the
spacer washer (A). (1x0,1mm, 2x0,2mm, 1x0,3mm)Fig. „W“
The prescoring device should have the same size (band)
than the saw blade of the machine, 2,8 mm – 3,6 mm are
possible.
The alignment of the scoring saw blade to the saw blade of
the machine will be adjusted with the screw (3) Fig. „V“. 1
rotation conforms 0,1 mm (Fig „Y“)
For checking make a cut sample.
If the machine is not used, prescoring device and the screw
(2) is to be dropped unter the table.
Fig. "U"
Fig. "V"
Fig. "W"
0,1 mm/
1,5 mm/
Fig. "Y"
A