Scheppach 19013 04901, Translation From Original Manual

Page: 26 / 80

26 english
Crosscut / mitre gauge
Fig. "R"
The crosscut / mitre gauge can be fitted to the left or to the
right of the sawblade.
The infinitely adjustable turning Zone is
0-60° on both sides
and is fixed with a tommy screw.
Fix the setting at
0° and 45° with the socket pin and tighten up
the tommy screw.
Folcling stop
(accessory)
The folding stop which is fitted onto the stop rail, is an ideal
supplement to the crosscut / mitre gauge.
The fine adjustment on the end stop enables exact settings via
the knurled screw.
Changing the sawblades
Fig. "S"
IMPORTANT!
Only use sharp, tear-free, unde- formed ,,Original
scheppach sawblades“.
If the saw blade slot becomec worn out replace the table inlay.
CAUTION!
When changing the sawblade take out the mains plug!
1 Holding mandre
2 Left-handed hex. nut M 20
• Take out the left-hand table inlay.
• Insert the holding mandrel (1) into the saw spindle through
the bore in the right-hand side of the table.
For releasing or tightening up the hex. nut M 20 (2) the saw
spindle is locked with the holding mandrel.
• Make note of the running direction of the sawblade.
Push-stick and push-grip
Fig. "T"
• For cutting narrow workpieces with a distance between the
sawblade and the stop rail of less than 120 mm, it is
essential to use the push-stick.
• For pushing narrow specially shaped workpieces use the
push-grip. The respective push-blocks can be prepared by
the User and attached to the push-grip.
Fig. "R"
Fig. "S"
Fig. "T"