8
ASSEMBLY INSTRUCTIONS
WARNING
The Bench Grinder is provided with a left and right two
piece Tool Rest. Right Tool Rest has a flat, smooth
surface to lay your workpiece against. Left tool rest is
used to sharpen twist drill bits.
1.
DO NOT
assemble the Bench Grinder until you are
sure the tool
IS NOT
plugged in.
2.
DO NOT
assemble the Bench Grinder until you are
sure the power switch is in the “OFF” position.
3.
DO NOT
assemble the Bench Grinder until you are
sure the grinding wheels are firmly tightened to the
Bench Grinder.
TOOL RESTS (Figs. D and E)
The Bench Grinder is provided with two different Tool
Rests assemblies. The Left Side Tool Rest is grooved
to accept drill bits. The Right Side Tool Rest is entirely flat.
1.
Assemble the Tool Rest Supports (A) to the inside
surface of the Wheel Covers (B) with the flat and lock
washers (C) and knobs (D) as shown. See Figure D.
2.
Assemble the Tool Rests (E) to the Supports (F)
with the flat washers (G) and Adjustment Knobs (H)
as shown. See Figure E.
3.
Adjust each Tool Rest until its inside edge (I) is
1/16” from the grinding wheel. Firmly tighten the
knobs holding the supports. See Figure E.
Fig. D
Fig. E
A
C
D
B
I
E
F
G
