10
OPERATING THE BENCH GRINDER
The Bench Grinder is designed for hand held grinding,
sharpening, and cleaning operations.
ALWAYS WEAR EYE PROTECTION!
Hot sparks are
produced during grinding operations.
Sharpening and removal of metal can be done on the
right side of the Bench Grinder using the grinding
wheel. Cleaning of metal surfaces can be done using
the wire wheel on the left side of the Bench Grinder.
4.
Allow the grinding wheels to come up to a steady
speed for at least one minute. The R.P.M.’s of the
Bench Grinder can be now increased to the desired
speed for the particular grinding operation by rotat-
ing the Variable Speed Switch clockwise.
5.
Adjust the eyeshields. Place the workpiece on the
appropriate tool rest for the desired operation.
6.
Move the workpiece towards the grinding wheel
until it lightly touches. Move the workpiece back
and forth across the front surface of the grinding
wheel removing the amount of material desired.
To avoid serious injury, never grind on the sides
of the grinding wheels.
7.
8.
The operator may place the hot end of the work-
piece into the water in the quench tray to cool it.
9. After completing the grinding operations, turn “OFF”
the Bench Grinder by pushing down on the Power
Switch. CAUTION: It will take a few minutes for the
grinding wheels to come to a complete stop.
10. Turn the Variable Speed Switch counterclockwise to
return it to its slowest setting.
CAUTION:
The Flexible Work Light housing will
remain hot for a few minutes after turning it “OFF”.
11. Avoid contact with housing until it is cool. Unplug
the Bench Grinder from the power source.
NOTE:
To prevent unauthorized use of the Bench
Grinder, the power switch has a removable locking key.
With the power switch in the “OFF” position, pull the
locking key out. The Bench Grinder cannot be turned
“ON” with the key removed. Insert the locking key to
resume grinding operations.
WARNING
1.
The Power Switch must be in the “OFF” position
and the Variable Speed Switch must be turned
to its slowest setting by being turned all the
way to the left until solid resistance is felt.
2.
Stand to the side of the Bench Grinder and plug in
the power cord to a suitable power source.
3.
Remain to the side of the Bench Grinder and turn it
“ON” by moving the power switch to the up position.
Low Speed 1745 RPM
Light Duty Operations
High Speed 3450 RPM
Heavy Duty/Normal Operations
Light Grinding
Sharpening
Rust and paint removal
Lowered grinding temperature
Heavy grinding
Stock Removal
Deburring
Buffing
GRINDING SPEED CHART
To use the Drill Bit Sharpening tool rest, lay the drill
bit flat in the “V” groove. Firmly hold on to the drill bit
shank. Slide the drill bit towards the grinding wheel
unit until it lightly touches. Keep the drill bit flat to
the plate and rotate the drill bit.
