EN
52
General Information About Lamps and Replacement of Lamps
Hood is equipped with a LED-based lighting system.
When LEDs are compared with ideal lighting and normal lamps, they provide a service
time 10 times longer, with energy savings up to 90%.
If you encounter any physical deformation of the lamp of the hood or any problem with
its lighting, please contact with the authorized service centre.
If there occurs ay crack or break on the surface of the lamp, contact with the authorized
service centre and replace it.
If it is required to replace the lamps, please check the following info and replace it with
an alternative having the same technical specifications.
- ILCOS D code: DBR-1-H (ILCOS d code as per standard IEC 61231)
- LED module – semi-transparent plastic
- Rated power of each lamp: 1W
- Maximum lamp potential power for replacement:
2 x 1W
- Voltage range of the lamp: 220 - 240V
- Product sizes: diameter: 35,8 mm / height: 30 mm
If required, you may acquire new lamps from the authorized service centre.
Replacement of the Lamps
Prior to replacement of the lamps, remove power cable of the hood. And then lift the
front glass upward and remove the aluminum cartridge filter. Afterwards:
1. Disconnect the female and male
connectors of the lamps by pushing back
part of the plastic lug as shown in the figure
at left here to release the locking
mechanism.
(Figure 13)
(Figure 13)
