25
NOTICE
1.
When you move the appliance, hold it at its base and lift it carefully. Keep the
appliance in an upright position.
2.
Never use the door for moving the appliance as you will damage the hinges.
3.
The appliance must be transported and installed by at least two persons.
4.
When you unpack the appliance, you should take note of the position of every
part of the interior accessories in case you have to repack and transport it at a
later point of time.
5.
Do not operate the appliance unless all components are installed properly.
6.
Do not stand or lean on the base, the drawers, the doors etc of the appliance.
7.
The air vents of the appliance or its built-in structure (if the appliance is
suitable for being built-in) must be completely open, unblocked and free of any
kind of dirt.
8.
Do not put any heavy items onto the open door of the oven. Do not lean
against the open door of the oven as you will damage the hinges.
2. Installation
2.1 Unpacking and positioning
1.
Unpack the appliance carefully. Dispose of the packaging as described in
chapter waste management.
2.
Completely remove the transport-protection. Be very careful and do not use any
aggressive or abrasive detergents to remove residuals of the transport-
protection.
3.
Check that the appliance and the power cord are not visible damaged.
4.
Do not install the appliance in a place where it may come in contact with water
or rain; otherwise the insulation of the electrical system will be damaged.
5.
Install the appliance on a level, dry and solid floor. Check the correct
installation with a bubble level.
6.
Remove the complete packaging material ( inside and outside the appliance)
before initial operation.
7.
The nameplate is situated inside the appliance or at the back.
