Fiber Collimators Series 60FC
Adjustment_60FC 10.12.2020 © Schäfter+Kirchhoff GmbH
Schäfter+Kirchhoff GmbH Kieler Str. 212 22525 Hamburg, Germany +49 40 85 39 97-0 [email protected] www.sukhamburg.com
3
2. Attaching a Fiber Cable to the Fiber Collimator
For attaching a fiber cable to the fiber collimator perform the following steps:
Figure 4:
To prevent damage to the sensitive
fiber end-face, always insert the fiber
connector`s ferrule
A
at an angle, with
the connector key
B
properly aligned
to the receptacle notch
C
.
Figure 5:
When the ferrule tip is safely located
in the inner cylinder of the receptacle,
align the connector to the
receptacle axis and carefully introduce
the connector into the fiber collimator.
Figure 6:
Then, orient the connector key in a
way that it is pressed gently onto
the right-hand side of the receptacle
notch.
Figure 7:
Gently screw on the connector cap
nut onto the receptacle until it is
finger-tight.
A
B
C
