Schaffner Group
User and Installation Manual
Ecosine
max
53/66
8.2.2 Screws and bolts selection
Depending on the cabinet specification, the heavy load fixation sys-
tem might be providing either screws/rods or nuts adapted to the
specific system. For the other part of the bolts (respectively the nut
or screw) Schaffner recommends zinc coated hex ribbed flange
steel screws or nuts. Respect filters weight for appropriate choice of
screws! Head diameters must not exceed these dimensions:
M12: d ≤24 mm
Refer to the cabinet supplier documentation for more information.
8.2.3 Filter placement:
1. Lift filter with appropriate crane using the two lifting slots (dimen-
sions of the slot 20x50mm).
2. Place the filter as precisely as possible by aligning the fixation
holes on the filter with the matching nuts holes or rods on the
base frame.
3. Insert the 4 screws or nuts and screw them approximately 1mm
before the head touch the surface.
4. Double check the proper alignment and parallel position.
5. Fix screws with appropriate torque (depending upon the material
of the cabinet fixation system and local standards).
Warning: the equipment weight is ≥ 240 kg
Handling and lifting of heavy equipment must always comply with
your local safety standard.
Figure 27 Location of lifting
slots
d
