Schaeffler HEATER Series, User Manual, Page: 18 / 30

18 Schaeffler Technologies
■
Swivel arm models: swivel the ledge open (towards you)
until it clicks in the safety positioning cam. Slide the
workpiece over the ledge until it is in the middle.
Swivel the ledge back to the pole.
■
Always make sure that the workpiece does not come into
contact with the plastic casing of the heater. When the
heating is finished, follow the instructions in reverse order.
Use heat-resistant gloves to move the heated workpiece.
■
This is only possible if the bore of the workpiece is large
enough to fit over the pole.
■
Place the workpiece as centrally as possible around the
pole on the horizontal supports.
■
The workpiece may not be wider than the
horizontal supports.
■
Always choose the largest induction ledge.
■
Make sure that the bare-metal sides are sufficiently coated
with lubricant to ensure optimal contact and avoid vibration.
7.2 Heating a horizontal
workpiece
■
Always make sure that the workpiece does not come into
contact with the plastic casing of the heater. When the
heating is finished, follow the instructions in reverse order.
Use heat-resistant gloves to move the heated workpiece.