background image

– 4 –

– PB –

RETROFITTING AN OLDER TABLE 

LOOM FOR THE FLOOR STAND

If you have an older model table loom 

without holes in the underside of the 

base, you need to drill holes in your loom 

as follows:

1. 

Remove the castle from the loom. 

Place the loom upside down on a firm 

surface.

2. 

Drill four holes into the loom sides 

using a 5/16" drill bit and the wooden 

drill guide provided. Align the guide 

firmly against the inside of the table loom 

leg. Drill each hole to a depth of 3/4". 

3. 

The drill guide has an A and a B end 

(Figure 3). For a 4-shaft loom, use end A 

only (Figure 4). 

4. 

The 8-shaft loom has a larger frame, 

so the holes at the rear of the loom are 

farther from the back legs. Use end A for 

the holes at the front of the 8-shaft loom 

and B for the holes at the rear of the 

8-shaft loom (Figure 5). 

  

FIGURE 3: DRILL GUIDE

A

B

FIGURE 4: 4-SHAFT TABLE LOOM BASE, UPSIDE DOWN WITH CASTLE REMOVED

A

A

table loom 
leg

back beam

loom side

front beam

FIGURE 5: 8-SHAFT TABLE LOOM BASE, UPSIDE DOWN WITH CASTLE REMOVED

A

B

back beam

loom side

front beam

table loom 
leg

Reviews: