– 2 –
– 3 –
TABLE LOOM FLOOR STAND
A
ssembly
I
nstructIons
then from the outer side of the stand,
insert the carriage bolt through the top
hole in an outside leg. Then place a #8
SAE washer on the carriage bolt and
secure the bolt with a 10-24 lock nut.
6.
From the inner side of the stand,
insert a 1/4-20 x 1-1/2" carriage bolt
through the top hole of the inside leg.
From the outside of the stand, place the
round hole in the metal support bar on
the carriage bolt. Secure the carriage bolt
with the washer wing nut and tighten
by hand. Now go back to the lock nut
attached in Step 5 and tighten it as much
as possible.
7.
Repeat steps 5 and 6 for the other
side of the stand and the remaining metal
support bar.
8.
Tighten all the bolts. Place the loom
on the stand by lining up the pins on the
top of the stand in the four holes on the
bottom of the loom.
FIGURE 1: TABLE LOOM STAND ASSEMBLY
barrel nuts
1/4-20 x 2" Phillips
truss head machine
screw truss screw
inside leg with
attached block
outside leg
metal support bar
FRONT OF STAND
cross braces
1/4-20 x 3" Phillips
truss head machine
screw truss screw
FIGURE 2: METAL SUPPORT BARS
10-24
lock nut
#8 SAE
washer
1/4-20 x 1-1/2"
carriage bolt
10-24 x 1-1/4"
carriage bolt
washer wing nut
