– 2 –
– 3 –
PARTS
2X
cross braces
2X
inside legs with attached blocks
2X
outside legs
1X
wooden drill guide (for older
looms only)
TOOLS NEEDED
slotted (flat) screwdriver
#2 Phillips screwdriver
3/8" wrench
7/16" wrench
drill and 5/16" drill bit (older looms only)
TABLE LOOM FLOOR STAND
A
ssembly
I
nstructIons
1.
Place the two cross braces
horizontally in front of you, with holes
facing up.
2.
Identify the two inside legs with
the blocks attached, and set these parts
perpendicular to the cross braces. The
blocks should be at the top, facing
outward.
3.
Attach the lower cross brace:
Insert a barrel nut into each hole of
one of the cross braces. Insert a 1/4-20
x 2" Phillips truss head machine screw
through the bottom hole of an inside leg
and tighten into into the barrel nut in the
lower cross brace (Figure 1). Repeat for
the other inside leg.
4.
Attach the upper cross brace: Place
the outside legs, with pins facing up, on
the outer side of the inside legs.
Insert
a barrel nut into each hole of the second
cross brace. Insert a 1/4-20 x 3" Phillips
truss head machine screw through the
bottom hole of the outside leg, then
through the middle hole of the inside leg.
Fasten the bolts into the barrel nuts in the
upper cross brace (Figure 1). Repeat with
the other outside leg.
5.
Attach the metal support bars:
Insert a 10-24 x 1-1/4" carriage bolt
through the square hole in the metal
support bar. Orient the support bar as
shown in Figure 2, with its jog pointing
inward toward the front of the loom,
HARDWARE
2X
metal support bars
2X
10-24 x 1-1/4" carriage bolts
2X
10-24 lock nuts
2X
#8 SAE washers
2X
1/4-20 x 1-1/2" carriage bolts
2X
1/4-20 washer wing nuts
2X
1/4-20 x 3" Phillips truss head
machine screws
2X
1/4-20 x 2" Phillips truss head
machine screws
4X
1/4-20 barrel nuts
washer wing nut
Phillips truss head machine
screw
lock nut
carriage bolt
barrel nut
washer
